Hey @TheDogMan,
Great feedback, I must have missed this step in the setup video. They do indeed install at the bottom of the wls shield. There is a hole for each. They lay horizontally.
Let me see if I can shoot another piece of video next week to fix this part up for ya’ll!
Cheers,
Stephen
The probes fall out every time I try to put it in. I did get them to semi stay sort of. I did fix this so it is normal now.
Also the drain tube with the metal filter does not even come close to the bottom of the tank as a water sensor and probes are in the way. So about 2 inches will never drain unless I move the drain hose outside the water shield where it can hit the bottom.
Up and running Grobo 1 and Grobo 2. 
White Widow about 3 week out in the Grobo 1 and just started Do Si Dos in the Grobo 2 today. I do need to watch this at first as it was not the exact Barneys Farm recipe.
I’m stuck on calibrating ph probe just keeps loading doent say anything
I might also put something on the website that the Grobo 2 uses the newer peat pod setup. It is is a good thing I think, but old Grobo users like me might be confused as I even bought a few more pods a few week back and didn’t order anything that fits the Grobo 2. I also did not know how to use the new setup, know its not hard, just more than popping in a pod like the older way. Mine fell in the tank a few times trying to get it to stay in. 
I think we need to start looking at alternative solutions to holding the fan up, as mine already fell and has only been up since last night. One of the magnet pieces pulled off the fan, so only 1 is holding it. I did push it back on of course, but the sticky tape or whatever on the magnet I am not sure can hold this up long term or not.
Here is my fix for the fan not staying up. I used one of the grow straps and wrapped it around the fan, then used that to mount it. No way is it falling now.
Hey @joe_Macias,
Try closing the app, then reopen it. Then head over to Settings and About My Grobo to update your Firmware version. Then you should be able to get out of the calibration loop you are experiencing.
If you continue to have issues, please email the team at support@grobo.io
Kindly,
Stephen
I’ve done that already but when I log back on app it puts me right back at that step its stuck I can’t go back any steps.
Thanks for the update @joe_Macias,
The software team is investigating this now, hang tight!
Kindly,
Stephen
Ok @joe_Macias,
Looks like we’ve identified a bug that we are currently squashing. In an hour or two can you try to update the app again? Close/Open should do it.
Cheers,
Stephen
Can do!
Looks like I might be having the water level problem someone else mentioned. I woke up to a dead dry seed and water level says fine, but waaaayyyyyyyyyyyyy to low, possibly 3-5 inches below where it should be? It will never hit the pod, not even close. Sticking my fingers in the hole and far as I could get them in and hardly hit the water.
Not about to waste another seed, Need to make sure it is right.
